Table of Contents
Advertisement
Monitor display
Appears when there are already 100 text memos and no more memos can be
INVALID
added.
Displayed while clip information is being read or when clip configuration has
changed. No operations can be performed while this display is on the screen.
[Meaning]
BUSY
• A card has been inserted or removed.
• Updating is in progress
• Recording post processing is in progress
• Other causes
Displayed for the first two seconds when the REC button is pressed to enter the
INT SG
EE mode and the INPUT SELECT VIDEO button or the INPUT SELECT AUDIO
button is set to SG.
Displayed for the first two seconds when the REC button is pressed to enter the
NO INPUT
EE mode and the INPUT SELECT button is set to a connector with no output
except for analog audio signals.
Displayed for two seconds when a text memo is added.
TEXT MEMO
Displayed for two seconds when a shot mark is added or deleted.
MARK ON/OFF
WARNING information
If "E- * * " Iights in the monitor display, hold down the SHIFT button and press the MENU button to open the DIAG-MENU and
read the warning information.
Display
No
Character code
04
UNKNOWN SIG
10
FAN STOP
11
NOT 1× 25M SIG
12
NOT 1× 50M SIG
14
NO MATCH SIG
15
NOT 1× DV SIG
16
INVALID VIDEO SIG
17
INVALID AUDIO SIG
18
INVALID TC SIG
21
REC WARNING
CARD
26
ERROR<******>
◆ NOTE:
*1 This warning appears only during recording. Then the audio is recorded mute.
*2 This warning appears only during recording. The internally generated time code is recorded.
154
For Long and Trouble-Free Operation: Error Messages
Description
Displayed when a signal input from the 1394 interface is not a DVCPRO or DV format
signal.
Displayed when the fan motor stops.
Displayed when a signal input from the 1394 interface is not a DVCPRO (25 Mbps) 1×
normal speed transfer signal.
Displayed when a signal input from the 1394 interface is not a DVCPRO50 (50 Mbps) 1×
normal speed transfer signal.
Displayed when signal input via the 1394 interface differs from the system format set on
this unit.
Displayed when a signal input from the 1394 interface is not a DV (25 Mbps) 1× normal
speed transfer signal.
Displayed when the compressed video data of a signal input from the 1394 interface is
irregular.
Displayed when the audio data of a signal input from the 1394 interface is irregular.
Displayed when the time code data of a signal input from the 1394 interface is irregular. Operation
Displayed when a video or audio error occurs during recording.
To continue operation, turn the power off and then back on again.
Displayed when data was corrupted due to a P2 card error during recording.
This error is displayed after recording ends and until the start of the next operation. This
error is not displayed during playback. (* indicates the slot number where the error
occurred.)
Replace the P2 card in the slot where the error occurred.
Description
Deck operation
Counter display
Operation
INVALID
continues
Operation
BUSY
continues
Operation
INT SG
continues
Operation
NO INPUT
continues
Operation
TEXT MEMO
continues
Operation
MARK ON /
continues
MARK OFF
Deck operation
Recording is
disabled
Operation
continues
Recording is
disabled
Recording is
disabled
Recording is
disabled
Recording is
disabled
Recording is
disabled
Operation
*1
continues
*2
continues
STOP
STOP
Advertisement
Table of Contents
