Table of Contents
Advertisement
The workflow for creating a play list is given below. A play list can be up to 24 hours long.
Preparing New Play Lists
This section describes how to delete a play list stored in the
play list area of this unit and how to prepare a new play list.
2
5
3
4
1
Select an edit format in the setup menu.
• Select an edit format. The unit will then be able to play
back only the selected format.
• Select playback channels for added audio.
◆ NOTE:
The settings in the following setup menus and play list menu
determine the edit format.
• 25 SYSTEM FREQ
(➝Refer to page
• 020 SYS FORMAT
(➝Refer to page
• 024 REC FMT(SD)
(➝Refer to page
• 025 REC FMT (HD)
• 026 PLY LST FMT
(➝Refer to page
*1 The following setup menu determines voice over settings only
when an AJ-YBX200G AVC-Intra codec board (optional
board) is installed.
• 792 A DUB CH
(➝Refer to page
• 793 A DUB PB MIX
74
Using Play List: Creating Play Lists
Creating Play Lists
Registering events and adding existing play lists
119.)
121.)
121.)
*1
(➝Refer to page
121.)
122.)
137.)
(➝Refer to page
137.)
Preparing new play lists
↓
↓
Saving play lists
2
Open the play list screen.
3
Press the MENU button.
4
Use the cursor buttons to choose [SETTING] –
[INSERT MODE] and press the SET button.
This selects INSERT and engages the insert edit mode.
5
Use the cursor buttons to choose [FILE] – [NEW].
◆ NOTE:
Holding down the SHIFT button and pressing the RESET button
performs the same function as [FILE] – [NEW].
6
Select [YES] and press the SET button.
This deletes the open play list and displays a new play list
without any events.
◆ NOTE:
• Be sure to choose [FILE] – [NEW] after changing the edit format
in the setup menu. Otherwise the edit format does not change.
Advertisement
Table of Contents
