Table of Contents
Advertisement
To Connect the P2 drive to a Personal Computer for External
Use
1
Attach the rubber feet to the dimples
on the base of the P2 drive.
Dimples
2
Start the personal computer.
3
Plug the AC adapter supplied with the
P2 drive into the DC IN 16 socket on
the P2 drive.
The P2 drive will start.
USB 2.0
4
Plug a USB 2.0 cable B connector into
the USB connector on the P2 drive.
USB 2.0
USB 2.0 connector
DC IN 16V
DC IN 12V
DC IN 16V
DC IN 12V
<Note>
No USB 2.0 cable is supplied with the P2
drive in the package. Use a commercially
available USB 2.0 cable (shielded).
Take care to use a USB cable that is no
longer than 3 metres. The P2 drive may not
operate properly with a cable longer than 3
metres.
5
Plug the other end (A connector) of
the USB 2.0 cable into the USB 2.0
port on the personal computer.
6
Verify that the personal computer
recognises the P2 drive.
<Notes>
In Windows XP, some card slots of the P2
drive may be assigned drive names that
have already been assigned to existing
networks. Reassign network drive names
if your personal computer does not
display all five card slots.
To disconnect the USB cable, select
"Safety Remove Hardware" from the
system tray on the taskbar, de-activate
[Panasonic P2 Series USB Device], then
unplug the cable.
9
Advertisement
Table of Contents
