Table of Contents
Advertisement
Installation
(continue)
To Connect the P2 drive to a Personal Computer for External Use
1
Attach the rubber feet to the dimples on the
base of the P2 drive.
Dimples
2
Start the personal computer.
3
Plug the AC adapter supplied with the P2
drive into the DC IN 16V socket on the P2
drive.
The P2 drive will start.
USB 2.0
IEEE 1394b
For the AJ-PCD20EJ only:
Plug the power switch box supplied with the
P2 drive into the DC IN 16V socket on the P2
drive, then plug the supplied AC adapter into
the power switch box. The P2 drive will start
when you turn ON the switch.
IEEE 1394b
USB 2.0
AC adapter
10
DC IN 16V
DC IN 12V
DC IN 16V
DC IN 12V
<Note>
Disconnect the AC mains plug from the AC
mains socket when not in use.
4
(To be connected by USB 2.0)
Plug a USB 2.0 cable B connector into the
USB connector on the P2 drive. then plug the
other end (A connector) of the USB 2.0 cable
into the USB 2.0 port on the personal
computer.
IEEE 1394b
USB 2.0
USB 2.0 connector
<Note>
No USB 2.0 cable is supplied with the P2
drive in the package. Use a commercially
available USB 2.0 cable (shielded).
Take care to use a USB cable that is no
longer than 3 metres. The P2 drive may not
operate properly with a cable longer than 3
metres.
For Macintosh, USB 2.0 operations are not
guaranteed.
DC IN 16V
DC IN 12V
Advertisement
Table of Contents
