Panasonic AJHPM110E - MEMORY CARD PORTABLE RECORDER/PLAYER Operating Instructions Manual page 119

Item
FR SUPER FR
No. DISP. No.
For AJ-HPM110P
0000
0001
0002
0003
0004
0005
0006
0007
0008
For AJ-HPM110E
25 SYSTEM FREQ
0000
0001
0002
0003
0004
0005
0006
0007
0008
0000
0001
26 HD SYS H ADV
0000
30 MENU LOCK
0001
Setting
SUPER
DISP.
Sets system frequency.
0: 59.94Hz
59.94
1: 50Hz
50
2: 23.98 Hz
23.98
3: 24 Hz
24
4: 29.97 Hz
29.97
5: 23.98 Hz
59-23
Receives 59.94 Hz input. Select this frequency to record 2:3 pull-down converted
60-24
(24-frame signal) output from VariCam: AJ-HDC27 series camera, AJ-HPX2000/2100,
25
AJ-HPX3000 or other camera.
60-25
6: 24Hz
Receives 60Hz input. Select this frequency to record 2:3 pull-down converted
59.94
(24-frame signal) output from VariCam: AJ-HDC27 series camera.
50
7: 25Hz
23.98
8: 25Hz
24
Receives 60Hz input. Select this frequency to record a variable frame rate set to 25p
29.97
from VariCam: AJ-HDC27 series camera.
59-23
NOTE:
60-24
• Changing this item will only cause the menu item to flash but the setting is not actually
25
reflected to this unit. For the changes to take effect, turn the power off and turn it back
60-25
on again.
• 2: 23.98 Hz and 3: 24 Hz are available only when the AJ-YBX200G AVC-Intra codec
board (optional board) is installed.
0H
59.94Hz
90H
Specifies whether or not HD output should advance 90H phase relative to SD REF input
during SD REF input.
0: Outputs HD at the same phase as SD REF.
1: HD output is output at a phase that is 90H advanced relative to SD REF.
NOTE:
• The audio output and TC output are output in the same phase as HD output.
• At 720p, the phase difference is 120H.
OFF Sets/releases the system file lock mode.
0: Releases the lock (file data can be changed)
ON
1: Lock is engaged (file data cannot be changed)
Settings and brief function description
29.97Hz only
119
Setup: Item Settings