Duplex solenoid and exit solenoid
Warning
Switch off the power and disconnect the power cord.
1.
Remove the front cover as described in "Front cover" on page 90.
2.
Remove the front shield plate.
3.
Free the front power supply fan.
4.
Disconnect the wiring harness of the solenoid you wish to remove.
5.
Remove the two screws securing the solenoid you wish to remove.
Remove the solenoid.
Exit Solenoid
Remove Screws
Removing the duplex solenoid and the exit solenoid
Reverse these steps to install the solenoids.
Duplex Solenoid
0725-65
Service Guide
123