Record Custom Voice Descriptors - Honeywell Lynx Plus Series Installation And Setup Manual

Honeywell lynx plus series security systems
Hide thumbs Also See for Lynx Plus Series:
Table of Contents

Advertisement

Lynx Plus Series Installation and Setup Guide
✻85 Record Custom Voice Descriptors
Use this mode to record up to 5 custom voice descriptors. To enter this mode, enter ✻85 while in
Programming mode.
Note: Entering a number other than one specified will give unpredictable results.
85 85 85 85
REC VOICE
REC
REC
REC
VOICE
VOICE DESCR
VOICE
DESCR
DESCR
DESCR
A A A A
DESC #
CUSTOM
CUSTOM DESC
CUSTOM
CUSTOM
DESC
DESC
Assign Custom Voice Descriptors
Entering "1" advances to the next prompt below. Entering "0" exits mode, upon which
"85" prompt blinks, indicating the mode is inactive.
SELECTIONS
0 = exit mode
1 = enter mode
Custom Descriptor Number
Record up to 5 custom words. Enter 7 + d + [✻]
Note: d = 0-4, each representing custom word 70, 71, 72, 73, or 74, respectively. Any
existing word will be announced
Press [#] to start recorder. Begin speaking immediately after the third beep. Speak the
desired word clearly near the microphone. Recording stops after 1.5 seconds.
SELECTIONS
0 = exit mode
1 = enter mode
6 = accept word and ready to record next descriptor prompt (A....7d)
[#] = re-record descriptor
00 = exit Record mode after pressing 6 to accept word
Press any key to repeat the recorded word.
- 54 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents