Programming From The Keypad - DKS 1803PC Owner's Manual

3.1.2 Programming from the Keypad

Follow the programming instructions as described in each section of this manual. The system will
prompt you with short tones (beep) when programming steps have been followed correctly, and with
a long tone (beeeeeep) when the programming step is ended. The display will also assist you in
viewing the information that you are programming. It is highly recommended that you complete the
resident listing in the appendix prior to starting any programming from the keypad. This listing will
provide you with the information needed to complete the manual programming sequence.
This symbol _ in the programming steps indicates numbers that you will need to enter, one number
per symbol. When programming from the keypad, after each programming step is performed
correctly, a short tone (beep) will be heard. When the programming session is ended, a long tone
(beeeeeep) will be heard.
NOTE: Relay hold open time zones, security levels, and elevator control functions cannot be
programmed from the system keypad. These functions can only be programmed from a PC
using the Remote Account Manager software, version 5.0.
30