Elevator Board Floor Hardware Test - DKS 1803PC Owner's Manual

6.1.4 Elevator Board / Floor Hardware Test
This testing sequence will allow you to check activation of individual relays on the elevator control
board(s) and will confirm communication between the telephone entry system circuit board and the
elevator control board(s).
1. Press *77 and enter the four-digit master code _ _ _ _ (beep).
The display will show: WHICH ELEVATOR? (1815 - 1817 systems only).
2. Enter the elevator shaft number (1, 2, 3 or 4) _ , then press * (beep).
The display will show: FLOOR? (1815 - 1817 systems only).
3. Enter the two-digit floor number _ _ , then press * (beep).
4. The relay LED on the elevator control board that represents the floor number entered will
turn ON for approximately 1 second.
5. To check other floor relays, repeat steps 2 and 3.
6. When complete with the testing, press 0# TOGETHER to end this testing sequence.
NOTE: This program test sequence will automatically end itself if no keypad inputs are
detected after approximately 30 seconds.
Refer to the Elevator Control board installation manual for more information on trouble
shooting the elevator control boards.
63