Accessories - DKS 1803PC Owner's Manual

6.2 ACCESSORIES

Surface Trim Ring
Flush Kit
Flush Ring
Stainless Steel Case
Surge Suppressers
Mounting Post
Telephone Test Set
Battery
Tracker Boards
RS-232 Cable
Elevator Board
Use to recess a surface mount unit into a wall or column. P/N 1803-150.
Use to install flush style units into a wall or column. Kit includes rough in
back box and trim ring. P/N 1814-165 comes with stainless steel trim
ring. P/N 1814-166 comes with gold plated trim ring.
Use to surface mount a flush style unit. P/N 1814-152.
Replaces the black steel surface mount case with a stainless steel case.
P/N 1810-102.
High voltage (115 V) suppresser. P/N 1878-076. Phone line
suppresser. P/N 1878-077. Low voltage (28 V) suppresser. P/N 1878-
078.
Heavy-duty goose-neck mounting post with mounting plate. P/N 1200-
048. Heavy-duty goose-neck mounting post with concrete base plate for
pad mounting. P/N 1200-047.
Includes clips, cord and carrying case. P/N 1800-050.
12 volt .8 amp hour gel cell provides stand by power during power
interruptions. P/N 1801-008.
Tracker expansion boards (P/N 2351-010) allow the 1815 / 1817 system
to operate up to sixteen individual doors or gates, provides door ajar and
forced entry alarms, and can activate local and building alarm systems.
Also allows DoorKing gate operators to report gate operator data and
activity to the entry system.
RS-232 cable with DB-9 connector on one end and wires on the other
end. Use this cable to program the entry system from a PC using RS-
232 communications instead of the modem. P/N 1818-040.
Elevator control boards (P/N 2348-010) provide control of up to four
elevators, with each elevator having a maximum of 64 floors.
64