Compaq ProLiant 5500 Setup And Installation Manual page 70

1. To add a processor, identify the processor locations as shown in
Figure 4-2.
NOTE. Processors can be installed in any processor socket. All four processor
sockets must have either a processor module or a terminator board installed
for proper bus termination.
Figure 4-2. Processor locations
2. Remove one of the terminator boards by turning the retaining knob
counterclockwise, releasing the side tabs and pulling up as shown in
Figure 4-3.
For use with Intel Pentium II Xeon processor-based servers only
4
3
2
1
Compaq ProLiant 5500 Servers Setup and Installation Guide
4-5