Compaq ProLiant 5500 Setup And Installation Manual page 132

SCSI Input 0 Channel
The SCSI Input 0 channel connects to SCSI hard drive slots 0 through 3, as
shown in Figure 7-12.
SCSI Input 1 Channel
The SCSI Input 1 channel connects to SCSI hard drive slots 4 through 7, as
shown in Figure 7-12. In this case, slots 4 through 7 become SCSI IDs 0
through 3, respectively, on the SCSI Input 1 channel. The SCSI Input 1 channel
can be routed to the removable media bay from the connector on the duplex
enabler board. You can use this for connecting to SCSI devices in the
removable media bay.
NOTE: When connecting from the duplex enabler board to SCSI devices in
the removable media bay, you must set the SCSI IDs for the devices in the
removable media bay to 4, 5, or 6.
2
1
5
3 3
2 2
6
1 1
0 0
7
Figure 7-12. SCSI Input 0 and 1 channels
For use with Intel Pentium II Xeon processor-based servers only
3
8
3 3
2 2
1 1
0 0
9
Compaq ProLiant 5500 Servers Setup and Installation Guide
4
10
7-17