Compaq ProLiant 5500 Setup And Installation Manual page 85
Pentium ii xeon processor-based servers
Hide thumbs
Also See for ProLiant 5500:
- Setup and installation manual (169 pages) ,
- Reference manual (36 pages) ,
- Safety information manual (204 pages)
Table of Contents
Advertisement
4-20
Installing Hardware Components
4.
Pull out the drive cage latch and push the drive cage back fully until the
drive cage latch can be pushed into place.
5.
Tighten the thumbscrews on the front of the drive cage.
6.
Connect SCSI controller cables. See Chapter 7, "Cabling," for
information on SCSI cabling. Figure 4-19 shows an example controller
connection.
Figure 4-19.
7.
Replace fans.
Example cable connection to SCSI controller
For use with Intel Pentium II Xeon processor-based servers only
Advertisement
Table of Contents
