Adding Ip Conference Stations Manually; Using Dhcp - Cisco IP CONFERENCE STATION 7936 Administration Manual

Chapter 2 Installing the Cisco IP Conference Station 7936

Adding IP Conference Stations Manually

Using DHCP

Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
OL-4746-01
If you want to assign specific directory numbers to your IP Conference Stations
without using auto-registration, you must manually add each station to the
Cisco CallManager database.
If you are not using Dynamic Host Configuration Protocol (DHCP) in your
network, you must also manually configure the IP settings and Trivial File
Transfer Protocol (TFTP) server on each station.
Alternatively, you can use DHCP, and manually set the TFTP server. In this case,
wait for the station to start up using DHCP, and then re-assign the TFTP server.
If you are using DHCP in your network without auto-registration, you must
manually add the IP Conference Station to the Cisco CallManager database.
The following procedure provides an overview of the steps you must perform;
refer to the Cisco CallManager documentation or online help for additional
information.
Start Cisco CallManager Administration.
Add an IP Conference Station to Cisco CallManager by selecting
Device > Add a New Device.
The Add a New Device page displays.
Choose Phone from the Device Type drop-down list box, and click Next.
The Add a New Phone page displays.
Choose the Cisco 7936 phone type and click Next.
The Phone Configuration page displays.
Enter the required fields.
Install the station by following the instructions in the
Cisco IP Conference Station 7936" section on page
Cisco IP Conference Station 7936 Administration Guide
Preparing to Install
"Installing the
2-6.
2-5