Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - REV1 Manual page 196

190 M R
ANAGING EPORTS
Table 9-3 Report Scheduling
Parameter
This report should be scheduled to run
Manually
Hourly
Daily
Weekly
Monthly
Allow this report to generate manually
Yes
No
The Report Layout window appears.
STRM Users Guide
Default Settings
Generates a report one time only. This is the default setting;
however, you may generate this report as often as required.
Schedules the report to generate at the end of each hour
using the data from the previous hour.
Using the drop-down list boxes, select a time frame to begin
and end the reporting cycle. A report is generated for each
hour within this time frame. Time is available in half-hour
increments. The default is 1:00 a.m for both From and To.
Schedules the report to generate each day using the data
from the previous day. Each chart on a report allows you to
select the previous 24 hours of the day, or select a specific
time frame from the previous day.
Click the check boxes beside each day you wish to generate
a report. Also, using the drop-down list box, select a time to
begin the reporting cycle. Time is available in half-hour
increments. The default is 1:00 a.m.
Schedules the report to generate each week using the data
from the previous week.
Select the day you wish to generate the report. Default is
Monday. Using the drop-down list box, select a time to begin
the reporting cycle. Time is available in half-hour increments.
The default is 1:00 a.m.
Schedules the report to generate each month using the data
from the previous month.
Using the drop-down list box, select the date you wish to
generate the report. The default is the 1st day. Also, using
the drop-down list box, select a time to begin the reporting
cycle. Time is available in half-hour increments. The default
is 1:00 a.m.
Enables manual generation of this report.
Disables manual generation of this report.