Connecting Components - Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV 1 Administration Manual
Strm log management administration guide
Hide thumbs
Also See for SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV 1:
Table of Contents
Advertisement
60
U
D
SING THE
EPLOYMENT
Step 4
Step 5
Step 6
Step 7
Connecting
Components
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
E
DITOR
From the Select a host to assign to list box, select a managed host to which you
wish to assign the new component. Click Next.
Click Finish.
Repeat for each component you wish to add to your view.
From the main menu, select File > Save to staging.
Once you add all the necessary components in your Event View, you must connect
your Event Processor(s) and Event Collector(s).
To connect components:
In the Event View, select the component for which you wish to establish a
connection.
From the menu, select Actions > Add Connection.
Note: You can also use the right mouse button (right-click) to access the Action
menu item.
An arrow appears in your map.
Drag the end of the arrow to the component on which you wish to establish a
connection. You can only connect Event Collectors to Event Processors.
The arrow connects the two components.
Repeat for all remaining components that you wish to establish a connection.
Specify a unique name for the source or target. The name can be up to 15
characters in length and may include underscores or hyphens. Click Next.
The event source/target information window appears.
Enter values for the parameters:
•
Enter a name for the off-site host - Specify the name of the off-site host. The
name can be up to 15 characters in length and may include underscores or
hyphens.
Enter the IP address of the server - Specify the IP address of the managed
•
host to which you wish to connect.
Encrypt traffic from off-site source - Select the check box if you wish to
•
encrypt traffic from an off-site source. To enable encryption, you must select
this check box on the associated off-site source and target.
Click Next.
Click Finish.
Repeat for all remaining off-site sources and targets.
From the main menu, select File > Save to staging.
Note: If you update your Event Collector configuration or the monitoring ports, you
must manually update your source and target configurations to maintain the
connection between deployments.
STRM Log Management Administration Guide
Advertisement
Table of Contents
