Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV 1 Administration Manual page 80
Strm log management administration guide
Hide thumbs
Also See for SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV 1:
Table of Contents
Advertisement
74
U
D
SING THE
EPLOYMENT
Step 5
E
DITOR
Enter values for the parameters:
Table 5-3 Host Context Parameters
Parameter
Disk Usage Sentinal Settings
Warning Threshold
STRM Log Management Administration Guide
Description
When the configured threshold of disk usage is exceeded,
an e-mail is sent to the administrator indicating the current
state of disk usage. The default is 0.75, therefore, when disk
usage exceeds 75%, an e-mail is sent indicating that disk
usage is exceeding 75%. If disk usage continues to increase
above the configured threshold, a new e-mail is sent after
every 5% increase in usage. By default, Host Context
monitors the below partitions for disk usage:
/
•
/store
•
/store/tmp
•
Specify the desired warning threshold for disk usage.
Note: Notification e-mails are send to the Administrative
Email Address and are sent from the Alert Email From
Address, which is configured in the System Settings. For
more information, see
Management
.
Chapter 3 Setting Up STRM Log
Advertisement
Table of Contents
Related Manuals for Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV 1
Related Products for Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV 1
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - AQL EVENT AND FLOW QUERY CLI GUIDE
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - CATEGORY OFFENSE INVESTIGATION GUIDE REV 1
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - EVENT CATEGORY CORRELATION REV 1
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - SNMP AGENT GUIDE REV 1
- Juniper STRM LOG MANAGEMENT 2008.2 - S 6-2008
- Juniper MEDIA FLOW CONTROLLER 2.0.4 -
- Juniper MEDIA FLOW MANAGER 2.0.2 - ADMINISTRATOR S GUIDE AND CLI
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - CONFIGURING INTRUSION DETECTION AND PREVENTION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - NSMXPRESS SERIES II REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - REV1
- Juniper MEDIA FLOW CONTROLLER 2.0.5
- Juniper NETWORK AND SECURITY MANAGER 2010.3
- Juniper 200 Series