Configuring System Notifications - Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV 1 Administration Manual

Configuring
System
Notifications
Step 1
Step 2
Step 3
You can configure global system performance alerts for thresholds using the
STRM Log Management Administration Console. This section provides
information for configuring your global system thresholds.
To configure global system thresholds:
In the Administration Console, click the System Configuration tab.
The System Configuration panel appears.
Click the Global System Notifications icon.
The Global System Notifications window appears.
Enter values for the parameters. For each parameter, you must select the following
options:
Enabled - Select the check box to enable the option.
•
Respond if value is - Specify one of the following options:
•
- Greater Than - An alert occurs if the parameter value exceeds the
configured value.
- Less Than - An alert occurs if the parameter value is less than the
configured value.
Resolution Message - Specify a description of the preferred resolution to the
•
alert.
Table 3-4 Global System Notifications Parameters
Parameter
User CPU usage
Nice CPU usage
System CPU usage
Idle CPU usage
Percent idle time
Run queue length
Number of processes in
the process list
System load over 1
minute
System load over 5
minute
System load over 15
minutes
Kilobytes of memory free
STRM Log Management Administration Guide

Configuring System Notifications

Description
Specify the threshold percentage of user CPU usage.
Specify the threshold percentage of user CPU usage at
the nice priority.
Specify the threshold percentage of CPU usage while
operating at the system level.
Specify the threshold percentage of idle CPU time.
Specify the threshold percentage of idle time.
Specify the threshold number of processes waiting for
run time.
Specify the threshold number of processes in the
process list.
Specify the threshold system load average over the last
minute.
Specify the threshold system load average over the last 5
minutes.
Specify the threshold system load average over the last
15 minutes.
Specify the threshold amount, in kilobytes, of free
memory.
31