Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV 1 Administration Manual page 47

Step 6
Step 7
Updating System
Time
Step 1
Step 2
Step 3
Step 4
Step 5
Update the passwords and confirm:
Note: Make sure you record the entered values.
• New Root Password - Specify the root password necessary to access the
web-based system administration interface.
Confirm New Root Password - Re-enter the password for confirmation.
•
Click Update Password.
You are able to change the time for the following options:
System time
•
• Hardware time
Time Zone
•
Time Server
•
Note: You must change the system time information on the host operating the
Console only. The change is then distributed to all managed hosts in your
deployment.
You can configure time for your system using one of the following methods:
• Configuring Your Time Server Using RDATE
Configuring Time Settings For Your System
•
Configuring Your Time Server Using RDATE
To update the time settings using RDATE:
In the Administration Console, click the System Configuration tab.
The System Configuration panel appears.
Click the System Management icon.
The System Management window appears.
For the host on which you wish to configure time, click Manage System.
Log-in to the System Administration interface. The default is:
Username: root
Password: <your root password>
Note: The username and password are case sensitive.
From the menu, select Managed Host Config > System Time.
The System Time window appears.
Caution: The time settings window is divided into four sections. You must save
each setting before continuing. For example, when you configure System Time,
you must click Apply within the System Time section before continuing.
STRM Log Management Administration Guide
Configuring Access Settings 41