Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV 1 Administration Manual page 75

You can add a non-NATed managed host using inbound NAT for the public IP
address and dynamic for outbound NAT but are located on the same switch as the
Console or managed host. However, you must configure the managed host to use
the same IP address for the public and private IP addresses.
When adding or editing a managed host, you can enable NAT for that managed
host. You can also use the deployment editor to manage your NATed networks
including:
Adding a NATed Network to STRM Log Management
•
Editing a NATed Network
•
Deleting a NATed Network From STRM Log Management
•
Changing the NAT Status for a Managed Host
•
Adding a NATed Network to STRM Log Management
To add a NATed network to your STRM Log Management deployment:
In the deployment editor, click the
Step 1
Note: You can also use the Actions > Managed NATed Networks menu option
to access the Managed NATed Networks window.
The Manage NATed Networks window appears.
Click Add.
Step 2
The Add New Nated Network window appears.
Enter a name of a network you wish to use for NAT.
Step 3
Click Ok.
Step 4
The Manage NATed Networks window appears.
Click Ok.
Step 5
A confirmation window appears.
Click Yes.
Step 6
STRM Log Management Administration Guide
Managing Your System View
NATed networks icon.
69