Table of Contents
Advertisement
Release 10.2.2
When an MD-Port-Number value greater than 65,535 is sent to an E120 or
E320 router by means of a COA request, the value that is displayed in the UDP
header of mirrored packets is the actual value minus 65,536. For example, an
MD-Port-Number of 65,540 is displayed in the mirrored packet as 4. [Defect ID
84712]
On the E120 and E320 routers, when a mirror rule is deleted after a CoA
request is sent with Juniper-LI-Action set to No-Action, the existing mirroring
session is not disabled. [Defect ID 84826]
No logs are created if you use the policy-list option when logging
policyMgrPacketLog events. [Defect ID 87203]
When you reload the slot holding a GE-2 or GE-HDE line module and you have
configured more than about 2000 policies with rate limiting on that module,
the drop count becomes more than expected. This unexpected drop count does
not occur when you create the same configuration after you reload the router to
the factory-default configuration. [Defect ID 175696]
On E320 line modules that support secure policies, the SRP module enables
you to configure more than 1022 secure policies per module. To avoid potential
performance issues, we recommend that you do not configure more than 1022
secure policies per module. [Defect ID 175756/ 183014/ 180360]
Unified in-service software upgrade (unified ISSU) is not supported on an E120
or E320 router if a hierarchical policy is attached to an external parent group.
[Defect ID 177478]
When you enter the no ip policy-parameter hierarchical parameterName
command or no ipv6 policy-parameter hierarchical parameterName
command for a hierarchical policy-parameter type in Interface Configuration
mode, the explicit reference of the parameter is removed successfully from the
interface. However, the Referenced by interfaces field in the output of the show
policy-parameter command does not change from the previously configured
value to implicit. [Defect ID 183957]
Work-around: To correct this problem, remove the entire interface
configuration.
PPPoE
The E Series router erroneously accepts a PADI with a payload length of 0
instead of rejecting it and incrementing the PPPoE Invalid PAD packet length
counter. [Defect ID 48356]
45
Known Problems and Limitations
Advertisement
Table of Contents
