Appendix A System Maximums - Juniper JUNOSE SOFTWARE 10.2.2 - RELEASE NOTES 6-4-2010 Release Note

Appendix A
System Maximums
This appendix presents current system maximums for various E Series hardware
configurations. An E Series router does not simultaneously support all maximum
configurations.
For some entries, early field trial (EFT) values are presented in addition to supported
values. These values have not been fully qualified by Juniper Networks and are
mentioned only for field test purposes in this release. EFT values are enclosed
within parentheses with an EFT designation; for example, (96,000 EFT).
Modules referred to in the tables are identified by their physical label. For module
specifications, including their identifying labels, see ERX Module Guide, Table 1,
Module Combinations and E120 and E320 Module Guide, Table 1, Modules and IOAs.
System Maximums for ERX310,
ERX7xx, and ERX14xx
General router values
Physical layer values
Link layer values
Routing protocol and performance values Routing Protocol Maximums on page 71
Policy and QoS values
Tunneling values
Subscriber management values
System Maximums for E120 and E320
Routers
General router values
Physical layer values
Link layer values
Routing protocol and performance values Routing Protocol Maximums on page 91
Policy and QoS values
Tunneling values
Subscriber management values
Section
General System Maximums on page 62
Physical and Logical Density Maximums on page 63
Link Layer Maximums on page 66
Policy and QoS Maximums on page 75
Tunneling Maximums on page 77
Subscriber Management Maximums on page 79
Section
General System Maximums on page 82
Physical and Logical Density Maximums on page 83
Link Layer Maximums on page 85
Policy and QoS Maximums on page 94
Tunneling Maximums on page 98
Subscriber Management Maximums on page 100
61