Juniper JUNOSE SOFTWARE 10.2.2 - RELEASE NOTES 6-4-2010 Release Note page 23

Deprecated Command
hostname
hssi description
hssi force dte acknowledge
hssi internal-clock
ignore dcd
ignore link-state-signals
[ no ] ike cr
l
interface hssi
invert tx clock
ip dhcp-local cable-modem
ip mirror
ip policy local-input
[ no ] ipsec isakmp-policy rule
ipv6 policy local-input
j1
license l2tp-session
lineCoding
log
log severity debug
dhcpLocalProtocolDecode
loopback
loopback remote { remote line fdl
ansi | remote line fdl bellcore |
remote line inband remote payload
[ fdl ] [ ansi ] }
mark
Command Mode
Domain Map Tunnel
Configuration
Still available in Global
Configuration mode
Interface Configuration
Interface Configuration
Interface Configuration
Interface Configuration
Interface Configuration
Global Configuration
Global Configuration
Global Configuration
Global Configuration
Global Configuration
Interface Configuration,
Profile Configuration
Global Configuration
Interface Configuration,
Profile Configuration
Controller Configuration
Global Configuration
Controller Configuration
Policy List Configuration
Global Configuration
Domain Map Configuration
Still available in Controller
Configuration and Interface
Configuration modes
Controller Configuration
Policy List Configuration
Release 10.2.2
Preferred Command
client-name
[ no ] ipsec crl
set dhcp-relay with the
strings docsis and pktc in
the server-string mapping
specification
ip policy secure-input and
ip policy secure-output; for
E120 and E320 routers, you
must use these commands
because the ip mirror
command has been
removed from the CLI for
those routers.
None
[ no ] ipsec ike-policy-rule
None
None
log in Classifier Group
Configuration mode
log severity debug
dhcpCapture
local-interface
mark in Classifier Group
Configuration mode
Known Behavior
15