Ospf; Rip; Rsvp-Te; Src Software And Sdx Software - Juniper JUNOSE SOFTWARE 10.2.2 - RELEASE NOTES 6-4-2010 Release Note

For e series broadband services routers
Table of Contents

Advertisement

JUNOSe 10.2.2 Release Notes

OSPF

RIP

RSVP-TE

SRC Software and SDX Software

Errata

54
Errata
After executing the clear ipv6 ospf process command, interfaces in the DOWN
state appear in the show ipv6 ospf database output. [Defect ID 90478]
OSPF adjacency might flap when ISSU is performed with OSPF default Hello
and Dead interval timers. [Defect ID 90562]
Problems with next hop in default RIP route advertisement. [Defect ID 90306]
SRP module reset type: processor exception 0x300 (read attempts) task:
rsvp_msgQueue_1 pc: 0x4d0547f0 -> Rsvp::doEndPointsChange [Defect ID
90246]
Problem with re-attaching policies on SDX managed DSI interfaces after a line
module reload. [Defect ID 87326]
SRP module reset type: processor exception 0x700 (program); task:
sssClient_Data_1 [Defect ID 89863]
On an ERX router configured for a LAG interface, the show sae interfaces and
the show sae subscribers command outputs display NasPortID as the interface
name of DSI interface created. [Defect ID 90208]
This section identifies errors found in the JUNOSe documentation. These errors are
corrected in subsequent releases of the affected documentation.
The Policy and QoS Maximums (for E120 and E320 routers) table in JUNOSe
Release Notes, Appendix A, System Maximums for Releases 9.x, 10.x, and 11.0.x
incorrectly states that the maximum number of policy classification (CLACL)
entries for the ES2 10G Uplink LM is 131,171.
The correct limit for CLACL entries for the ES2 10G Uplink LM in these releases
is 65,535.
The Link Layer Maximums table (for the E120 and E320 routers) in Appendix A,
System Maximums, of the JUNOSe 10.2.0 Release Notes, incorrectly refers to a
note for the maximum number of Ethernet S-VLANs per IOA for ES2 10G ADV
LMs. Although the entries in the table for the IOA combinations supported with
the ES2 10G ADV LM are correct, a note in this table section states that no more
than 16,384 S-VLANs are supported per LM. However, this limitation does not
apply to ES2 10G ADV LMs, which support a maximum of 32,768 S-VLANs per
LM.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 10.2.2

Table of Contents