Release Highlights; Sdx Software And Src Software; Early Field Trial Features; Dhcp - Juniper JUNOSE SOFTWARE 10.2.2 - RELEASE NOTES 6-4-2010 Release Note

Release Highlights

SDX Software and SRC Software

Early Field Trial Features

DHCP

Release 10.2.2 is a maintenance release and includes the feature described in this
section.
Transfer of Calling Station ID to PDP
JUNOSe Software now supports sending of the calling station ID to the Policy
Decision Point (PDP) for a virtual router. To enable this functionality, use the
sscc option send-calling-station-id command in Global Configuration mode.
The following command has been modified in this release:
sscc option
The output of the following command has been modified in this release:
show sscc option
Change in existing behavior: New feature added as described here.
The features described in this section are present in the code but have not yet been
fully qualified by Juniper Networks. These features are available only for field test
purposes in this release. If you use any of these features before they have been fully
qualified, it is your responsibility to ensure that the feature operates correctly in
your targeted configuration.
Support for DHCP External Server, DHCP Local Server, DHCP Relay, and DHCP
Relay Proxy on POS Access Interfaces
The following packet over SONET (POS) module combinations on E Series
routers now support configuration of the DHCP external server, DHCP local
server, DHCP relay, and DHCP relay proxy applications, alone or in
combination, when the POS module is the access interface:
POS module combinations on the E120 router and the E320 router:
ES2 4G LM with ES2-S1 OC12-2 STM4 POS IOA
ES2 4G LM with ES2-S1 OC48 STM16 POS IOA
Release 10.2.2
7
Release Highlights