Juniper JUNOSE SOFTWARE 10.2.2 - RELEASE NOTES 6-4-2010 Release Note page 63

The Link Layer Maximums table (for the E120 and E320 routers) in Appendix A,
System Maximums, of the JUNOSe Release Notes, for the following releases
incorrectly stated that the maximum number of Ethernet S-VLANs per ES2-S2
10GE PR IOA with an ES2 10G LM or ES2 10G Uplink LM was 32,768:
Releases 10.2.0 and 10.2.1
Release 10.3.0
The correct limit for Ethernet S-VLANs per ES2-S2 10GE PR IOA on these LMs in
these releases is only 16,384. The increased scaling maximum of 32,768
Ethernet S-VLANs per ES2-S2 10GE PR IOA, in these releases, applies only to
the ES2 10G ADV LM.
The Link Layer Maximums table (for the E120 and E320 routers) in Appendix A,
System Maximums, of the JUNOSe 10.2.0 Release Notes, failed to mention that
the maximum number of software lookup blocks per ES2 10G Uplink LM on
E120 and E320 routers was 16,383.
This scaling limitation on the software lookup blocks for ES2 10G Uplink LMs
applies to JUNOSe Release 10.2.0 and higher-numbered releases.
The SRC Software and SDC Software section in the Subscriber Management
Maximums table (for the ERX310, ERX7xx, and ERX14xx routers) in Appendix
A, System Maximums, of the JUNOSe Release Notes, for the following releases
incorrectly mentioned that the maximum number of SRC interfaces supported
on all the ERX routers was 48,000.
Release 9.0.3
Release 9.1.3
Releases 9.2.2 and 9.2.3
Releases 9.3.1 and 9.3.2
Releases 10.0.1 and 10.0.2
Releases 10.1.0, 10.1.1, and 10.1.2
Releases 10.2.0 and 10.2.1
Release 10.3.0
The correct maximum number of SRC interfaces supported on the different
ERX routers is as follows:
16,000 interfaces on the ERX310 router
32,000 interfaces on the ERX705 and ERX710 router
32,000 interfaces on the ERX1410 router
48,000 interfaces on the ERX1440 router
Release 10.2.2
55
Errata