Table of Contents
Advertisement
JUNOSe 10.2.2 Release Notes
BFD
Bridged Ethernet
CLI
36
Known Problems and Limitations
When 16,000 PPPoA interfaces are configured on an OCx/STMx ATM line
module paired with an OC3-4 I/O module in an ERX14xx model, ERX7xx
model, or ERX310 router, Ping traffic passing through the line module on the
restarting router experiences an outage of 103 seconds, which is beyond the
maximum limit, after a unified ISSU from JUNOSe Release 9.2.0p1-0 to
9.3.0b0-12. This outage does not occur when the same configuration is applied
on a Gigabit Ethernet interface. [Defect ID 179794]
At the major interface level, the inPacketDiscards counter includes both
inPacketsDropped and inPacketUnknownProtocol statistics. The
inPacketUnknownProtocol statistics should be displayed by a separate counter.
[Defect ID 44286]
When you configure an ATM PVC where PCR = SCR and maximum burst size
is zero, the CLI returns an error indicating the burst size is invalid and it does
not create the VC. [Defect ID 58357]
Work-around: Configure a CBR or a UBR plus PCR to create the circuit with the
same parameters, depending on the desired priority for the traffic. CBR has a
high priority and UBR plus PCR has a medium priority.
After you have shut down the interface to the next hop (for the route that is
used to establish the BFD session), output for the show bfd session command
erroneously indicates the shutdown interface as Management Interface
(FastEthernet 6/0). [Defect ID 174271]
The CLI erroneously permits you to configure bridge1483 encapsulation over
AAL5MUX IP even though that configuration is not supported. [Defect ID
35013]
When you issue a run show ppp command, the CLI changes the configuration
level of the command line to Global Configuration mode rather than remaining
at the level from which you issued the command. [Defect ID 52165]
Work-around: Reissue the commands necessary to reenter the desired mode.
The logout subscribers all command may not log out all of the DHCP
subscribers. Although the bindings and DHCP addresses are cleared, the show
subscribers summary command may display some of the DHCP subscribers.
[Defect ID 180176]
Work-around: Try using the dhcp delete-binding all command. If this does
not clear the subscribers, you may want to reload the line module to avoid
further issues.
Advertisement
Table of Contents
