Forwarding; Hardware; Igmp; L2Tp - Juniper JUNOSE SOFTWARE 10.2.2 - RELEASE NOTES 6-4-2010 Release Note

Forwarding

Hardware

IGMP

IP

L2TP

MPLS

LM10A or LM10+ crashes when removing merge policies; file:
aptationLayer.cc; line: 7515; task: scheduler. [Defect ID 185102]
Packets with router alert IP option configured are sent to SRP though the source
addresses in the packets are not local and the associated protocol is disabled.
[Defect ID 88859]
Unable to send message type X to address (15a15 0) because ICC returned
error code Y log message not clear. [Defect ID 89524]
LM10 Memory leak due to PPP or DHCP subscriber flap. [Defect ID 90570]
Gigabit Ethernet interface in failed state where link is down but interface is up.
[Defect ID 89942]
Serial number for fan in show hardware command output is not updated when
fan is swapped. [Defect ID 90008]
The output of the show ip traffic command erroneously displays IGMP packets
on ES2 10G LM, as multicast packets. [Defect ID 90041]
Executing BFD last-resort also enables RTR last-resort. [Defect ID 89510]
Although the IP access-internal route is deleted from the routing table after you
issue the shutdown command on a major PPP interface, or after you issue the
logout subscribers all command and the subscribers try to log in again,
logging in of PPP subscribers fails. This problem occurs because the AAA server
that authenticates subscribers responds with a message that access is denied
owing to detection of duplicate addresses. Also, the
message is recorded in the aaaUserAccess event log category
address detected
that you can view from the output of the show log command. [Defect ID
185109]
SRP reset type: processor exception 0x68616c74 (halt) task: ip_Ctrl_2 with
continuous SNMP polling. [Defect ID 90472]
LDP and OSPF flap when an unconfigured LM10 is reloaded with 75k MPLS
next hops. [Defect ID 90471]
Release 10.2.2
access denied: duplicate
Resolved Known Problems
53