Juniper IP SERVICES - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 310

JUNOSe 11.1.x IP Services Configuration Guide
284
Monitoring IP Reassembly
host1#show ip tunnel reassembly statistics detail
Tunnel IP Reassembly Statistics for Virtual Router: default
Tunnel IP Reassembly enabled
Total Fragments Received:
Total Packets Reassembled:
L2TP:
GRE:
IPSec:
Control/Other:
Total Reassembly Errors:
Fragmentation Errors:
Too Many Fragments:
Out of Resources:
Packet Too Big:
Reassembly Timeout:
Reassembly Disabled Discards:
Example 3 Shows reassembly statistics for virtual router vr2 before and after
setting a statistics baseline
The following command shows reassembly statistics for vr2 before setting the
baseline.
host1:vr2#show ip tunnel reassembly statistics
Tunnel IP Reassembly Statistics for Virtual Router: vr2
Tunnel IP Reassembly enabled
Total Fragments Received:
Total Packets Reassembled:
Reassembly Errors:
Reassembly Discards:
The following command sets a baseline for reassembly statistics on vr2.
host1:vr2#baseline ip tunnel-reassembly
The following command shows reassembly statistics relative to the baseline
before new packets arrive at the router for reassembly.
host1:vr2#show ip tunnel reassembly statistics delta
Tunnel IP Reassembly Statistics for Virtual Router: vr2
Tunnel IP Reassembly enabled
Total Fragments Received:
Total Packets Reassembled:
Reassembly Errors:
Reassembly Discards:
The following command shows reassembly statistics relative to the baseline as
new packets start arriving at the router for reassembly.
15
5
5
0
0
0
0
0
0
0
0
0
0
45
15
0
0
0
0
0
0