Juniper IP SERVICES - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 298

JUNOSe 11.1.x IP Services Configuration Guide
272
Monitoring Dynamic IP Tunnels
Tunnel transport virtual router Name of the virtual router associated with
the tunnel
Tunnel mdt Tunnel MDT state
Tunnel checksum option State of the checksum feature: enabled or disabled
Tunnel sequence number option State of the sequence number feature;
enabled or disabled
Tunnel up/down trap is enabled Indicates whether or not the E Series router
sends traps to SNMP when the operational state of the tunnels changes
Tunnel server location Location of the tunnel server in slot/port format
(ERX7xx models, ERX14xx models, and the ERX310 router) or
slot/adapter/port format (E120 and E320 routers).
Tunnel secured by ipsec transport interface IPSec interface that secures
the tunnel.
Tunnel administrative state Configured state of the tunnel: Up or Down
Statistics Details of packets received or transmitted by the tunnel
packets Number of packets received or transmitted by the tunnel
octets Number of octets received or transmitted by the tunnel
discards Number of packets not accepted by the tunnel
Errors Number of packets with errors received or transmitted by the tunnel
Data rx Received data
Data tx Transmitted data
DVMRP tunnels found Total number of DVMRP tunnels found
Tunnels were created dynamic Number of tunnels created dynamically
Example 1 Displays three dynamic DVMRP tunnels
host1:vr11#show dvmrp tunnel
DVMRP tunnel mvpn-dynamic-1 is Up
DVMRP tunnel mvpn-dynamic-2 is Up
DVMRP tunnel mvpn-dynamic-3 is Down
3 DVMRP tunnels found
3 tunnels were created dynamic
Example 2 Displays the detail of a dynamically created DVMRP tunnel for the
data MDT application
host1:vr11#show dvmrp tunnel detail mvpn-dynamic-1
DVMRP tunnel mvpn-dynamic-1 is Up
tunnel is dynamic
Application is MVPN
Tunnel operational configuration
Tunnel mtu is '5000'