Juniper IP SERVICES - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 280

JUNOSe 11.1.x IP Services Configuration Guide
254
Monitoring IP Tunnels
Tunnel destination address IP address of the destination of the tunnel
Tunnel transport virtual router Name of the virtual router associated with
the tunnel
Tunnel up/down trap Indicates whether or not the E Series router sends
traps to SNMP when the operational state of the tunnels changes, enabled
or disabled
Tunnel server location Location of the tunnel server in slot/port format
(ERX7xx models, ERX14xx models, and the ERX310 router) or
slot/adapter/port format (E120 and E320 routers).
Tunnel secured by ipsec transport interface IPSec interface that secures
the tunnel.
Tunnel administrative state Configured state of the tunnel: up or down
Statistics Details of packets received or transmitted by the tunnel
Packets Number of packets received or transmitted by the tunnel
Octets Number of octets received or transmitted by the tunnel
Discards Number of packets not accepted by the tunnel
Errors Number of packets with errors received or transmitted by the tunnel
Data rx Received data
Data tx Transmitted data
Number of tunnels found Total number of DVMRP tunnels found
Number of static tunnels Number of tunnels created statically
Example 1
host1#show dvmrp tunnel
DVMRP tunnel boston1 is up
1 DVMRP tunnel found
1 tunnel was created static
Example 2
host1#show dvmrp tunnel detail
DVMRP tunnel boston1 is up (tunnel is static)
Tunnel operational configuration
Tunnel name is 'boston1'
Tunnel mtu is '10240'
Tunnel source address is '0.0.0.0'
Tunnel destination address is '0.0.0.0'
Tunnel transport virtual router is vr1
Tunnel up/down trap is enabled
Tunnel server location is 4/0
Tunnel secured by ipsec transport interface 1
Tunnel administrative state is up
Statistics packets
Data rx 0
octets discards
0 0
errors
0