Monitoring Ancp - Juniper IP SERVICES - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x IP Services Configuration Guide
access node responds with the result of the triggered loopback test by means of a
GSMP port management message. For example, when using an ATM-based local-loop,
the ANCP operation can trigger the access node to generate ATM (F4/F5) loopback
cells on the local loop.
l2c oam

Monitoring ANCP

You can display ANCP information with the following commands.
show adjustment-factor
206
Monitoring ANCP
Use to trigger the access node to run a local loopback test on the specified
interface.
Field descriptions
Request status Status of the OAM request (succeeded or failure)
Response code Code that returned with the OAM response
DEFAULT RESPONSE Response string (if any) that was included in the
OAM response
Example 1
host1#l2c oam interface atm 4/1.103
request succeeded
0x503 : DSL line status showtime.
DEFAULT RESPONSE
Example 2
host1#l2c oam neighbor accessnode_1002 end-user-id enduser_1002
request succeeded
0x503 : DSL line status showtime.
DEFAULT RESPONSE
There is no no version.
See l2c oam.
Use to display the configured values for the adjustment factor applied to the
upstream data rate and downstream data rate reported by ANCP for each DSL
type. The adjustment factor is used to generate an accurate QoS shaping rate.
Field descriptions
L2C QoS Adjustment Rates List of all DSL types and the corresponding
adjustment factor for each
ADSL1 Adjustment factor for the ADSL1 DSL type
ADSL2 Adjustment factor for the ADSL2 DSL type
ADSL2+ Adjustment factor for the ADSL2+ DSL type