Juniper IP SERVICES - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 150

JUNOSe 11.1.x IP Services Configuration Guide
124
Monitoring BFD
Echo mode disabled/inactive
2 Clients:
Client OSPFv2, desired tx: 0.3, required rx: 0.3, multiplier 3
Client ISIS, desired tx: 0.3, required rx: 0.3, multiplier 3
TX FC-assisted? Yes, Detection FC-assisted? Yes
Example 3 IPv6 version
host1#show bfd session detail
Address fe80:1234::abcd
State UP on Interface FastEthernet1/3
Detection Time0.900, version v1
Local discriminator 3, Remote discriminator 1
Session up time 00:00:01:04, Up/Down count 1, Adaptivity disabled
Local: min tx interval 0.3, min rx interval 0.3, multiplier 3
(Adapted) min tx interval 0, min rx interval 0, multiplier 4
Remote: min tx interval 0.3, min rx interval 0.3, multiplier 3
Local diagnostic: None, Remote diagnostic: None
Remote heard, hears us
Min async interval 0.3, min slow interval 0.3
Echo mode disabled/inactive
1 Client:
Client OSPFv3, desired tx: 0.3, required rx: 0.3, multiplier 3
See show bfd session.