Juniper IP SERVICES - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 80

JUNOSe 11.1.x IP Services Configuration Guide
show ip protocols
54
Monitoring Routing Policy
Prefix-tree with the last deletion/insertion: t_abc5
ip prefix-tree name t_abc1:
count: 1
ip prefix-tree name t_abc2:
count: 5
ip prefix-tree name t_abc3:
count: 1
See show ip prefix-tree.
Use to display detailed information about the protocols currently configured on
the router.
Use the summary keyword to display only a list of the configured protocols.
For field descriptions, see the show commands for the individual routing protocols
in their respective Configuration Guide chapters.
Example
host1#show ip protocols
Routing Protocol is
Default local preference is 100
IGP synchronization is enabled
Always compare MED is disabled
Router flap damping is disabled
Administrative Distance: external 20 internal 200 local 200
Neighbor(s):
No neighbors are configured
Routing for Networks:
Routing Protocol is
Distance is 110
Address Summarization:
None
Routing for Networks:
Routing Protocol is
Router Administrative State: enable
System version RIP1: send = 1, receive = 1 or 2
Update interval: 30 seconds
Invalid after: 180
hold down time: 120 seconds
flushed interval: 300 seconds
Filter applied to outgoing route update is not set
Filter applied to incoming route update is not set
No global route map
Distance is 120
Interface Tx
Routing for Networks:
10.2.1.0/255.255.255.0
See show ip protocols.
bgp 1"
ospf 255" with Router ID 100.100.100.1
rip"
seconds
Rx Auth