Configuring The Mobile Ip Home Agent - Juniper IP SERVICES - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x IP Services Configuration Guide
5.
6.
7.
8.
9.
10.
The following example illustrates this procedure:
For information about configuring virtual routers and access lists, see the JUNOSe
System Basics Configuration Guide. For information about configuring IP interfaces,
see the JUNOSe IP, IPv6, and IGP Configuration Guide.
For information about configuring B-RAS licenses, RADIUS authentication servers,
and RADIUS accounting servers, see the JUNOSe Broadband Access Configuration
Guide.

Configuring the Mobile IP Home Agent

To configure the Mobile IP home agent on a virtual router:
1.
2.
3.
320
Configuring the Mobile IP Home Agent
(Optional) Configure the B-RAS license.
(Optional) Configure a RADIUS authentication server on the router.
(Optional) Configure a RADIUS accounting server on the router.
Configure a loopback interface to be used as the primary interface for a tunnel.
Configure an interface profile for mobile host associations.
Configure a destination profile for dynamic GRE or DVMRP tunnels, as described
in "Configuring Dynamic IP Tunnels" on page 261.
! Create a virtual router.
host1(config)#virtual-router test
! Configure an access list.
host1:test(config)#access-list test deny ip host 100.1.1.3 any log
! Configure an IP interface.
host1:test(config)#interface loopback 0
host1:test(config-if)#ip address 10.10.10.1 255.255.255.255
! Configure the IP router ID.
host1:test(config)#ip router-id 10.10.10.1
! Configure the B-RAS license.
host1:test(config)#license b-ras demo
! Configure an authentication server.
host1:test(config)#radius authentication server 10.209.13.234
host1:test(config-radius)#key secret
host1:test(config-radius)#udp-port 1812
host1:test(config-radius)#radius update-source-addr 10.209.12.2
! Configure an accounting server.
host1:test(config-radius)#radius accounting server 10.209.13.234
host1:test(config-radius)#key secret
host1:test(config-radius)#udp-port 1813
! Create the primary interface for the tunnel.
host1:test(config)#interface loopback 1
! Configure a profile for mobile host associations.
host1:test(config)#profile virDefault
Configure a license for the Mobile IP home agent.
Configure the Mobile IP home agent settings.
Configure one or more mobile hosts.