Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
6.3.5 show dot1q-tunnel
This command displays all interfaces enabled for Double VLAN Tunneling.
Format
Modes
Interface
6.3.6 show dot1q-tunnel interface
This command displays detailed information about Double VLAN Tunneling for the
specified interface.
Format
Modes
Interface
Mode
Customer Id
EtherType
6-18
show dot1q-tunnel
Privileged EXEC
User EXEC
Valid slot and port number separated by forward slashes.
show dot1q-tunnel interface [<unit/slot/port> |
all]
Privileged EXEC
User EXEC
Valid slot and port number separated by forward slashes.
This field specifies the administrative mode through which
Double VLAN Tunneling can be enabled or disabled. The
default value for this field is disabled.
This is a 12-bit customer ID which will be used as the last 12
bits of the Double VLAN Tunnel. The valid range for a cus-
tomer ID is 0 to 4095.
This field represents a 2-byte hex EtherType to be used as the
first 16 bits of the DVLAN tunnel. There are three different
EtherType tags. The first is 802.1Q, which represents the
commonly used value of 0x8100. The second is vMAN,
which represents the commonly used value of 0x88A8. If
EtherType is not one of these two values, then it is a custom
tunnel value, representing any value in the range of 0 to
65535.
v3.0, January 2008
VLAN Commands