System Utility Commands; Traceroute; Clear Config; Clear Counters - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

18.2 System Utility Commands

This section describes the commands you use to help troubleshoot connectivity issues and
to restore various configurations to their factory defaults.

18.2.1 traceroute

Use the
traceroute
traveling to their destination through the network on a hop-by-hop basis. The
value should be a valid IP address. The [port] value should be a valid decimal integer in
the range of 0(zero) to 65535. The default value is 33434.
The optional port parameter is the UDP port used as the destination of packets sent as part
of the traceroute. This port should be an unused port on the destination system.
Format
Mode

18.2.2 clear config

This command resets the configuration to the factory defaults without powering off the
switch. When you issue this command, a prompt appears to confirm that the reset should
proceed. When you enter
Format
Mode

18.2.3 clear counters

This command clears the statistics for a specified
for the entire switch based upon the argument.
Format
Mode

18.2.4 clear igmpsnooping

This command clears the tables managed by the IGMP Snooping function and attempts to
delete these entries from the Multicast Forwarding Database.
Format
Mode
18-18
command to discover the routes that packets actually take when
traceroute <ipaddr> [port]
Privileged EXEC
, you automatically reset the switch.
y
clear config
Privileged EXEC
clear counters {<unit/slot/port> | all}
Privileged EXEC
clear igmpsnooping
Privileged EXEC
v3.0, January 2008
<unit/slot/port>,
System Maintenance Commands
<ipaddr>
for all the ports, or