Show Dvlan-Tunnel; Show Dvlan-Tunnel Interface - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

6.3.7 show dvlan-tunnel

This command displays all interfaces enabled for Double VLAN Tunneling.
Format
Modes
Interface

6.3.8 show dvlan-tunnel interface

This command displays detailed information about Double VLAN Tunneling for the
specified interface. Use the "all" option to see information about all the interfaces.
Format
Modes
Interface
Mode
Customer Id
EtherType
VLAN Commands
show dvlan-tunnel
Privileged EXEC
User EXEC
Valid slot and port number separated by forward slashes.
show dvlan-tunnel interface [<unit/slot/port> |
all]
Privileged EXEC
User EXEC
Valid slot and port number separated by forward slashes.
This field specifies the administrative mode through which
Double VLAN Tunneling can be enabled or disabled. The
default value for this field is disabled.
This is a 12-bit customer ID which will be used as the last 12
bits of the DVLAN Tunnel. The valid range for a customer
ID is 0 to 4095.
This field represents a 2-byte hex EtherType to be used as the
first 16 bits of the DVLAN tunnel. There are three different
EtherType tags. The first is 802.1Q, which represents the
commonly used value of 0x8100. The second is vMAN,
which represents the commonly used value of 0x88A8. If
EtherType is not one of these two values, then it is a custom
tunnel value, representing any value in the range of 0 to
65535.
v3.0, January 2008
6-19