Gmrp Commands; Set Gmrp Adminmode - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Port GMRP Mode

8.3 GMRP Commands

This section describes the commands you use to configure and view GARP Multicast
Registration Protocol (GMRP) information. Like IGMP snooping, GMRP helps control
the flooding of multicast packets. GMRP-enabled switches dynamically register and de-
register group membership information with the MAC networking devices attached to the
same segment. GMRP also allows group membership information to propagate across all
networking devices in the bridged LAN that support Extended Filtering Services.
Note: If GMRP is disabled, the system does not forward GMRP messages.

8.3.1 set gmrp adminmode

This command enables GARP Multicast Registration Protocol (GMRP) on the system.
The default value is disable.
Format
Mode
8.3.1.1 no set gmrp adminmode
This command disables GARP Multicast Registration Protocol (GMRP) on the system.
Format
Mode
GARP, GVRP, and GMRP Commands
Leave All Period Timer is set to a random value in the range
of LeaveAllTime to 1.5*LeaveAllTime. Permissible values
are 200 to 6000 centiseconds (2 to 60 seconds). The factory
default is 1000 centiseconds (10 seconds).
Indicates the GARP Multicast Registration Protocol (GMRP)
administrative mode for the port, which is enabled or dis-
abled (default). If this parameter is disabled, Join Time,
Leave Time and Leave All Time have no effect.
set gmrp adminmode
Privileged EXEC
no set gmrp adminmode
Privileged EXEC
v3.0, January 2008
8-7