Kyocera KM-1530 Instruction Handbook Manual page 85

3. Memory Card / RAM Disk
3-3-5 Reading print data
Perform the following procedure when you want to read print data that has been saved on a Memory Card or RAM Disk.
* In 20 ppm copiers, reading print data is accomplished from the operation panel on the copier itself. Refer to "2. Printer Settings (20 ppm
copier)" on page 2-1 for information on the appropriate procedure.
* Verify beforehand that the Memory Card is in a write-enabled state and that the RAM Disk is turned ON.
* To verify saved data and the corresponding partition name, it is helpful to print out the Partition List. Refer to "3-3-7 Printing out the Partition
List" for information on printing that list.
* In 20 ppm copiers, Partition List print out is accomplished from the operation panel on the copier itself. Refer to "2. Printer Settings (20 ppm
copier)" on page 2-1 for information on the appropriate procedure.
Procedure
1 Open an MS-DOS Prompt in Windows.
2 Type in the command to read data and then press the ENTER key.
[Example] To read the print data entitled "SAMPLE.txt" from a Memory Card
* To read the data from a RAM Disk, simply change the "A" parameter to "0".
C:\WINDOWS>ECHO !R! RWER R,A,2,"SAMPLE.txt"; EXIT;>LPT1
3 Print out of the corresponding data will begin.
3-3-6 Deleting print data or font data
Perform the following procedure when you want to delete print data or font data that has been saved on a Memory Card or RAM Disk.
* In 20 ppm copiers, deleting data is accomplished from the operation panel on the copier itself. Refer to "2. Printer Settings (20 ppm copier)"
on page 2-1 for information on the appropriate procedure.
* Verify beforehand that the Memory Card or RAM Disk contains the data that you want to delete.
* To verify saved data and the corresponding partition name, it is helpful to print out the Partition List. Refer to "3-3-7 Printing out the Partition
List" for information on printing that list.
* In 20 ppm copiers, Partition List print out is accomplished from the operation panel on the copier itself. Refer to "2. Printer Settings (20 ppm
copier)" on page 2-1 for information on the appropriate procedure.
Procedure
1 Open an MS-DOS Prompt in Windows.
2 Type in the command to delete data and then press the ENTER key.
[Example] To delete the print data entitled "SAMPLE.txt" from a Memory Card
* To delete the data from a RAM Disk, simply change the "A" parameter to "0".
* To delete font data, simply change the "2" parameter to "1".
C:\WINDOWS>ECHO !R! RWER D,A,2,"SAMPLE.txt"; EXIT;>LPT1
3 Deletion of the corresponding data will begin.
4 Print out the Partition List to verify whether or not the data was deleted properly.
3-5