Kyocera KM-1530 Instruction Handbook Manual page 80

2. Printer Settings (20 ppm copier)
Item No.
Receive dump mode
55
The data that the printer receives for
debugging programs and files is turned into
hexadecimal code and printed out. If "OK" is
selected here, this receive dump mode will
be activated. The receive dump mode will be
canceled under the following circumstances:
• Form feed is initiated (by selecting the
"GO" command in the printer mode and
then pressing the Enter key).
• A force-print time-out occurs.
Printer reset
56
Resets the Printer Board only even without
turning the power to the machine OFF.
Resource protect mode
57
Protects the resource data of fonts and
macros downloaded through PCL6 and,
even if the emulation protocol is switched,
the PCL resource will be saved in the
printer's memory. If "Permanent" is selected
here, temporary resources will not be saved.
If, however, "Per/Temp" is selected,
temporary resources will also be saved.
Auto Continue ON/OFF
58
If one of the following error messages
appears and "On" has been selected here,
the error state will be released and the
printing operation will be restarted
automatically after a specified amount of
time.
"Memory overflow"
"Print overrun"
Recovery time for Auto Continue
59
Sets the amount of time before Auto
Continue engages when "On" is selected
under the "Auto Continue ON/OFF" setting
(item No.: 58). If "000" seconds is selected
here, Auto Continue will engage immediately
after the error.
Service Rep Status Page print out
60
Prints out a Status Page for use by your
service representative.
Item Display message
Print HEX-DUMP
Printer Reset
Resource pro.
Auto Continue
Change #
Print Status page
Available settings
OK
OK
Off, Permanent,
Per/Temp
On, Off
000 - 495 (sec.)
No, Print
2-12
Remarks
At least 16 MB of additional
memory (option) must be installed.
Displayed only when "On" is
selected under the "Auto Continue
ON/OFF" setting (item No.: 58).