Kyocera KM-1530 Instruction Handbook Manual page 18

Error code Display message
(15 ppm copier) (20 ppm copier)
E82 Memory overflow
E83 Interface occupied
EF1 checksum error
EF2 RAM error
<15 ppm copier>
The current print job could not be completed due to insufficient memory in the
printer.
• If you are using a RAM disk, reduce the size of the RAM disk. If this error occurs
often, it is recommended that you install additional memory into the printer. For
more detailed information on adding memory, contact your service representative
or an authorized service center.
• If you want to force-continue the print job, press the Start key. The data that has
already been processed will be printed out and the remaining portion of the print
job will be printed onto the following page.
• If "Auto Continue" (menu: P74) is turned "On" (setting: 1), the printing operation
will be restarted automatically after the amount of time specified there.
<20 ppm copier>
The current print job could not be completed due to insufficient memory in the
printer.
• Press the Printer key to switch to the printer mode. Three different commands will
be displayed. Use the M and N keys to move the arrow e until it points to the
desired command and then press the Enter key.
GO: Continues printing. The data that has already been processed will be printed
out and the remaining portion of the print job will be printed onto the following
page.
CANCEL: Cancels the printing operation completely.
RESET: Resets the Printer Board. (Only printer functions will be reset.)
• If you are using a RAM disk, reduce the size of the RAM disk. If this error occurs
often, it is recommended that you install additional memory into the printer. For
more detailed information on adding memory, contact your service representative
or an authorized service center.
• If "Auto Continue" is turned "On", the printing operation will be restarted
automatically after the amount of time specified there.
The selected interface is currently in use. Wait for a while and then attempt the
operation again.
An error has been detected during operation. Turn the main switch to the printer
OFF (O) and then back ON ( | ) again. If the same error message remains, contact
your service representative or an authorized service center.
An error has been detected during operation. Turn the main switch to the printer
OFF (O) and then back ON ( | ) again. If the same error message remains, contact
your service representative or an authorized service center.
3. Troubleshooting
Procedure
13