Kyocera KM-1530 Instruction Handbook Manual page 17

3. Troubleshooting
Error code
(15 ppm copier)
E60 RAM disk error Press GO
E70 MemoryCard err Press GO
E71 Memory Card err Insert again
E72 Insert the same memory card
E73 Format error Memory card
E80 Print overrun
12
Display message
(20 ppm copier)
<15 ppm copier>
A read- or write-error has occurred on the RAM disk. Press the Start key to erase
the error indication.
<20 ppm copier>
A read- or write-error has occurred on the RAM disk. First press the Printer key to
switch to the printer mode. Next, select the "GO" command and then press the
Enter key. The error indication will be erased.
<15 ppm copier>
A read- or write-error has occurred in the Memory Card (CompactFlash). Press the
Start key to erase the error indication.
<20 ppm copier>
A read- or write-error has occurred in the Memory Card (CompactFlash). First
press the Printer key to switch to the printer mode. Next, select the "GO" command
and then press the Enter key. The error indication will be erased.
The Memory Card (CompactFlash) was removed during operation under the menu
for printer-related settings. Reinsert the Memory Card.
* BE SURE to turn the main switch OFF (O) BEFORE inserting the Memory Card.
The Memory Card (CompactFlash) could not be detected during an operation in
which the printer was reading data from that card. Reinsert the Memory Card.
* BE SURE to turn the main switch OFF (O) BEFORE inserting the Memory Card.
Initialization of the Memory Card (CompactFlash) currently inserted is necessary.
<15 ppm copier>
A data overrun error has occurred due to insufficient memory.
• If you want to force-continue the print job, press the Start key. If you want to
cancel the printing operation completely, press the Stop/Clear key.
• If "Auto Continue" (menu: P74) is turned "On" (setting: 1), the printing operation
will be restarted automatically after the amount of time specified there.
• Once this error message is displayed, "Page Protect" (menu: P42) will be turned
"On" (setting: 1) automatically.
<20 ppm copier>
A data overrun error has occurred due to insufficient memory.
• Press the Printer key to switch to the printer mode. Three different commands will
be displayed. Use the M and N keys to move the arrow e until it points to the
desired command and then press the Enter key.
GO: Continues printing.
CANCEL: Cancels the printing operation completely.
RESET: Resets the Printer Board. (Only printer functions will be reset.)
• If "Auto Continue" is turned "On", the printing operation will be restarted
automatically after the amount of time specified there.
• Once this error message is displayed, "Page Protect" will be turned "On"
automatically.
Procedure