Hot Swapping The Fan Unit; Hot Swapping Power Supplies - Cisco SFS-7012 - SFS InfiniBand Server Switch 7012 Hardware User's Manual

Step 4 Push the handles in to fully close.

Hot Swapping the Fan Unit

Loosen the captive panel screw.
Step 1
Step 2 Pull the panel screw down to partially disengage the unit.
Slowly pull the unit. The unit will disengage from the connector.
Step 3
Carefully slide the fan out until it is completely removed from its slot.
Step 4
To install a fan unit:
Place the unit into the slot. Slowly slide the fan unit in until it engages into the connector.
Step 1
Step 2 Using the panel screw, push up to re-engage the unit.
Tighten the captive panel screw.
Step 3

Hot Swapping Power Supplies

The SFS 7012 switch requires a minimum of three power supplies for normal operation. Power supplies
can be hot swapped without powering down the switch. To replace a power supply:
Loosen the captive panel screw.
Step 1
Pull the panel screw down to partially disengage the unit.
Step 2
Slowly pull the unit. The unit will disengage from the connector.
Step 3
Carefully slide the power supply out until it is completely removed from its slot.
Step 4
To install a power supply:
Step 5
Place the unit into the slot. Slowly slide the power supply in until it engages into the connector.
Step 6
Step 7 Using the panel screw, push up to re-engage the unit.
Step 8 Tighten the captive panel screw.
Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide
40
Chapter
OL-8787-04