Cisco SFS-7012 - SFS InfiniBand Server Switch 7012 Hardware User's Manual page 66

Figure 3-15 Reboot Screen
Select the radio button of the spine(s) to be rebooted, or select the Reboot Entire Chassis radio button
Step 2
to reboot the SFS 7012 chassis and all spines.
Click Reboot.
Step 3
Rebooting Multiple Managed Spines
In a redundant management configuration it may occasionally be necessary for the user to reboot both
managed spines. This is accomplished through the CLI of the master spine.
Access the master spine CLI via Telnet, SSH, or through the SFS 7012 RS232 serial ports.
Step 1
The system prompts for a user name. At the prompt enter:
Step 2
The system prompts for a password. At the prompt enter:
Step 3
The system responds with:
To reboot multiple spines on the SFS 7012 enter the following command:
Step 4
where:
•
•
•
Note If accessing the CLI through Telnet or SSH, the user will need to reconnect to the CLI following the
reboot.
Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide
48
admin
adminpass
Welcome to the SFS 7012 CLI. Type 'list' for the list of commands.
reboot now -m -n
now initiates the reboot process as soon as the user presses Enter (i.e., no system y/n prompt).
-m reboots just the management card of the master spine. This is a non-disruptive reboot (i.e., the
reboot will not interfere with any switch traffic).
-n reboots just the management card of the slave spine (in a non-disruptive manner).
Chapter
OL-8787-04