Configuring An Inventory Scan Schedule For The Management Zone - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ASSET INVENTORY REFERENCE 10.3 30-03-2010 Reference Manual

You can define the scan schedule settings at three levels:
Management Zone: The settings are inherited by all device folders and devices. To schedule a
scan for the Management Zone, see
for the Management Zone," on page
Device Folder: The settings are inherited by all devices contained within the folder or its
subfolders. Overrides the Management Zone settings. To schedule a scan for devices in a
folder, see
Device: The settings apply only to the device for which they are configured. Overrides the
settings at the Management Zone level and device folder level. To schedule a scan for a device,
see Section 2.2.3, "Configuring an Inventory Scan Schedule for a Device," on page
2.2.1 Configuring an Inventory Scan Schedule for the
Management Zone
1 In ZENworks Control Center, click Configuration, then in the Management Zone Settings
panel, click Inventory.
2 Click Inventory Schedule in the category list.
3 In the Schedule Type field, select what type of schedule you want to use.
No Schedule: No scan is scheduled. See
Date Specific: Scans run on specified dates. See
Recurring: Scans run on a recurring schedule. See
Event: Scans are triggered by an event. See
No Schedule
1 Select No Schedule in the Schedule Type field.
2 Click Apply or OK.
No automatic scans are configured.
Date Specific
1 Select Date Specific in the Schedule Type field.
24 ZENworks 10 Configuration Management Asset Inventory Reference
Section 2.1.2, "Configuring a Scan for Devices in a Folder," on page
Section 2.2.1, "Configuring an Inventory Scan Schedule
24.
"No Schedule" on page
"Date Specific" on page
"Recurring" on page
"Event" on page
17.
38.
24.
24.
25.
31.