Event Code Overview - Novell ACCESS MANAGER 3.1 SP1 - EVENT CODES Manual

Event Code Overview

1
Event codes for Access Manager consist of 4 fields that describe the type of code and the module
that produced it:
Severity (1 digit)
1 = severe - Describes problems that needs to be resolved in order for the system to run
correctly.
2 = error - Describes that a failure occurred, but the system is operational.
3 = warn - Describes a situation that may exist that the administrator should be aware of
and may need to address. The system is currently running properly
4 = config - Describes configuration related information.
5 = info - Describes events that occur.
6 = debug - Describes execution points within the software.
9 = internal - Describes an error that is for internal use only. This error code will not be
documented in any public documentation.
Component issuing the error code (3 digits)
Sub-grouping for further classification within a component (2 digits)
Event code (three digits)
0 000
Severity Component field
The following sections divide the event codes by component, then describe them:
Chapter 1, "Event Code Overview," on page 9
Chapter 2, "Administration Console (009)," on page 11
Chapter 3, "Identity Server (001)," on page 51
Chapter 4, "Linux Access Gateway Appliance(045)," on page 91
Chapter 5, "SSL VPN Server (005)," on page 93
Chapter 6, "J2EE Agents (006)," on page 97
Chapter 7, "Server Communications (JCC) (007)," on page 103
Chapter 8, "Policy Engine (008)," on page 125
Chapter 9, "SOAP Policy Enforcement Point (011)," on page 131
Chapter 10, "Backup and Restore (010)," on page 137
Chapter 11, "Novell Modular Authentication Class (012)," on page 143
00
Sub-grouping
000
Event Code
Event Code Overview
1
9