Novell ACCESS MANAGER 3.1 SP1 - EVENT CODES Manual page 132

Event Code
501101020
501101021
101101022
201101023
501101030
201101030
132 Novell Access Manager 3.1 SP1 Event Codes
Description
Request Received
Response Sent
Unsupported request received
Unrecognized Policy Identifier
Configure Success
Configure Warning
Remedy
Soap request received.
Cause: Informational message which logs
the type of request received
Action: None. Informational message used
for checking soap handler interactions.
Soap response sent.
Cause: Informational message regarding
soap response to a request
Action: None. Informational message used
for checking soap handler interactions.
A NXPES command other than configure,
evaluate or terminate was received.
Cause: The policy engine revision is
incompatible with the application.
Action: Validate the software installation.
Policy evaluation was requested for an
unknown policy.
Cause: The policy identifier known to the
Access Gateway is stale.
Action: Most often, this problem is
detected by the Access Gateway and the
policies are reconfigured. If the problem
persists, send an Apply or Apply Changes
to the device from the CLI or Administrative
Console.
Successful policy configuration.
Cause: Policy configuration succeeded
Action: None. Informational message used
for checking policy configuration.
Policy Configuration Warning.
Cause: Policy configuration request
reported a problem in retrieving
configuration data from the config store
Action: Check the policy definitions in the
Administration Console to ensure the
configuration store is working properly, then
reapply the configuration to the device.