Novell ACCESS MANAGER 3.1 SP1 - EVENT CODES Manual page 133

Event Code Description
101101031 Configure Failure
501101032 Configure - Empty Policy Set
501101040 Terminating policy
501101050 Evaluating policy
Remedy
The policy requested is malformed or
causes an exception during the
configuration process.
Cause: This is accompanied with a
possible reason for the failure.
Action: Check the policy configuration in
the administrative console and reapply the
configuration to the device.
The set of policies requested either do not
apply to the policy enforcement point or the
set of policies do not match the categories
selected in the policy enforcement list.
Cause: This may be normal operation.
Action: If a policy is expected, check the
category of the policy and make sure the
policy is enabled for the device.
The set of policies represented by the
policy ID are no longer needed and will be
removed from the operating policy set.
Cause: This happens each time a
configuration is applied to the device.
Action: None. This is an informational
message only.
An evaluation request has been received
for the set of policies represented by the
policy ID.
Cause: This happens at least once per
user session per configured policy
enforcement point.
Action: None. This is an informational
message only.
SOAP Policy Enforcement Point (011) 133