Error Code - Dialogic DSI SPCI Network Interface Boards Programmer's Manual

Dialogic
Parameter Description:

Error Code

The Error Code is coded as shown in the following table:
Value Mnemonic
0x31 S7E_RESET_ERR
0x33 S7E_POOL_EMPTY
0x34 S7E_TX_FAIL
0x35 S7E_HDR_ERR
0x36 S7E_LEN_ERR
0x37 S7E_MSU_SEND
0x39 S7E_BAD_PRIM
0x3a S7E_BAD_LLID
0x3b S7E_MEM_ERR
0x3c S7E_RTVL_ERR
0x51 MTP_BAD_PRIM
0x52 MTP_POOL_EMPTY
0x53 MTP_TX_FAIL
0x54 MTP_LEN_ERR
0x55 MTP_SLT_FAIL
0x57 MTP_TALLOC_ERR
0x58 MTP_BAD_ID
0x59 MTP_MALLOC_ERR
0x5a MTP_BSNT_FAIL
0x5b MTP_RTV_FAIL
0x5c MTP_BAD_FSN
0x5d MTP_BAD_COO
0x5e MTP_SNMM_ERR
0x5f MTP_SLTM_ERR
0x60 MTP_NO_COA
0x61 MTP_NO_CBA
0x66 MTP_TIM_ERR
0x67 MTP_RRT_OVRFLW
0x68 MTP_FLUSH_FAIL
0x69 MTP_FLUSH_L2
®
DSI SPCI Network Interface Boards Programmer's Manual Issue 5
ID Description
MTP2 Failed to initialize.
l2_llid No free buffers in MTP2 transmit pool.
l2_llid Failed to send LSSU/FISU to driver.
l2_llid No room to add level 2 header, SU not
transmitted.
l2_llid Length Error, SU not transmitted.
l2_llid Failed to send SU to lower layer, protocol
should handle retransmission.
l2_llid MTP2 unable to accept primitive.
l2_llid Invalid l2_llid in HDR structure.
l2_llid MTP2 memory allocation error.
l2_llid MTP2 failure to perform retrieval.
0 MTP3 unable to accept primitive.
0 No free frames in MTP3 transmit pool.
0 MTP3 failed to send MSU to lower layer.
0 MSU too long for buffer.
link_id Signaling link test failure.
0 MTP3 Failed to allocate T_FRAME.
0 Invalid ID in message HDR.
0 MTP3 unable to allocate MSG.
link_id Failure to retrieve BSNT.
link_id Retrieval failure.
link_id Erroneous FSN in COA.
link_id COO received after changeover complete.
0 Internal software error.
0 Internal software error.
link_id Failed to receive COA.
link_id Failed to receive CBA.
timer ref MTP3 attempt to re-use active timer resource.
Messages discarded due to overflow of Re-
Routing buffer.
link_id MTP3 failed to receive Flush Ack from level 2.
link_id MTP2 transmission buffers flushed (due to
RPO).
85